ISO 9001: 2000 Certified

60˚ Tilt Both Ways

• 3˚ And Straight Column in one machine

• Patent pending Easy Load Guide Blocks

• Optional Power Tilt

SPARTAN S330

Available in 220 Volt Single Phase.

STANDARD SPARTAN MODEL Hercules S330 SWIVEL HEAD, HIGH SPEED, HORIZONTAL, METAL CUTTING BANDSAW WITH 2 H.P., AND 60 DEGREE HEAD SWIVEL

•  Capacity @ 90°:  13” x 18” (330 x 460mm) 13” round (330mm)

•  Capacity @ 45°:  12” x 12” (300 x 300mm) 12”  round (300mm)

•  Capacity @ 30°:   6” x 11” ( 150 x 280mm)   6” round (150mm)

•  Blade:    13’ 10” x 1” x .035” (4216  x 25  x .9 mm) 

•  Blade Tension:  Manual tension (30,000 psi) provides consistent square cutting accuracy.  The blade tension devise comes to a positive stop assuring the proper tension after each blade change.

•  Speed Range:  Blade speed is variable through a precision balanced step pulley and heavy-duty worm gear transmission.  Blade speeds are 90, 140, 220 and 320 SFPM.  The broad     speed range allows for optimum cutting of a large spectrum of materials.

•  Hydraulic Down Feed:  Infinitely variable feed rate is hydraulically controlled for fast, accurate cutting.  Settings are made at the operator’s station.

•  Motors:  Blade Drive:  2 H.P. (1.5kW).   Drive motor is dual voltage, 230/460 Volts, 3 Ph, 60 Hz.    208 volt conversion is available for an added charge.

•  Blade Guides:  Carbide Blade Guides provides reduced vibration, heat and blade stress providing longer blade life and accuracies of + .002 per inch of cut material.

• Chip Brush:  Powered from the drive wheel of the saw, the brush changes speed with the blade to assure that chips are being removed from each gullet, improving cutting performance and blade life. 

• Vise Jaw:  The Quick Acting vise jaw arrangement makes material clamping fast and easy while always holding the work piece secure.  The cast iron vise jaws can be quickly positioned next to the material size, then manually clamped using the dual cam-lock device from either the front or rear of the machine.

•  Swivel:  The saw frame swivels a full 60 degrees for added capabilities for miter cutting.  The pivot shaft has sealed bearings for maintenance free operation, while a pointer and angle scale make setup fast and easy.

•  Operators Control Panel:  Operation of the machine is made safe and easy from the fixed position control panel.  Control Voltage is 110V.

 Machine Weight: 1800 lbs.

 Machine Dimensions: 75 3/4” W x 75 3/16” L x 53 1/8” H

[Home] [Up] 

This site is best viewed with Internet Explorer 6.x and a screen resolution of 1024x768